Articles citing this article

The Citing articles tool gives a list of articles citing the current article.
The citing articles come from EDP Sciences database, as well as other publishers participating in CrossRef Cited-by Linking Program. You can set up your personal account to receive an email alert each time this article is cited by a new article (see the menu on the right-hand side of the abstract page).

Cited article:

Small-Quantity Cooling Lubrication in Creep-Feed Grinding: Surface Quality and Residual Stress Analysis

Ali Basem, Malak Naji, Hasan A. Al-Asadi, Mohammad Sediq Safi, Gulrux Daminova, Merwa Alhadrawi, Mohamad J. Alfaker and Saiful Islam
Results in Engineering 102348 (2024)
https://doi.org/10.1016/j.rineng.2024.102348

Steady and Periodical Heat-Mass Transfer Behavior of Mixed Convection Nanofluid with Reduced Gravity, Radiation and Activation Energy Effects

Cyrus Raza Mirza, Zia Ullah, A. Dahshan, Md. Mahbub Alam, Khadija M. Abualnaja, Hanaa Abu-Zinadah, Abdullah A. Faqihi and Nidhal Ben Khedher
Case Studies in Thermal Engineering 105376 (2024)
https://doi.org/10.1016/j.csite.2024.105376

Applicability of nano-cutting fluids for enhanced cooling, low tool wear, and high tribological performance during machining—a review

Milon Selvam Dennison, S. Kirubanidhi Jebabalan and Debabrata Barik
Discover Applied Sciences 6 (12) (2024)
https://doi.org/10.1007/s42452-024-06398-9

Environmental sustainability during machining of hardened steel using nanofluid: A case study

Saswat Khatai, Ashok Kumar Sahoo, Ramanuj Kumar, Amlana Panda, D.A. Joshi, N.B. Ibrahim and D.M. Sangeetha
E3S Web of Conferences 405 04042 (2023)
https://doi.org/10.1051/e3sconf/202340504042

Grinding with minimum quantity lubrication: a comparative assessment

Y. S. Dambatta, Changhe Li, Min Yang, L. I. Beikai, Teng Gao, Mingzheng Liu, Xin Cui, Xiaoming Wang, Yanbin Zhang, Zafar Said, Shubham Sharma and Zongming Zhou
The International Journal of Advanced Manufacturing Technology 128 (3-4) 955 (2023)
https://doi.org/10.1007/s00170-023-11962-5

Development of OCMNO algorithm applied to optimize surface quality when ultra-precise machining of SKD 61 coated Ni-P materials

Le Anh Duc, Pham Minh Hieu and Nguyen Minh Quang
Manufacturing Review 10 7 (2023)
https://doi.org/10.1051/mfreview/2023006