Open Access
Review
Table 1
Typical parameters considered during non-conventional machining.
| Parameters | Machining techniques | |||
|---|---|---|---|---|
|
|
||||
| EDM | USM | LBM | ECM | |
| Material removal rate | * | * | * | * |
| Tool /Electrode wear rate | * | * | * | * |
| Surface roughness | * | * | * | * |
| Electrolyte fluid velocity, m/s | – | – | – | * |
| Applied voltage | * | – | – | * |
| Type of electrolyte used / Dielectric fluid | * | – | – | * |
| Concentration of electrolyte | – | – | – | * |
| Initial interelectrode gap thickness, mm | * | – | – | * |
| Back pressure of electrolyte | – | – | – | * |
| Flow rate | – | – | – | * |
| Pulse frequency | * | – | * | – |
| Duty ratio | * | – | – | – |
| Pulse on/off time | * | – | – | – |
| Pulse interval/duration | * | – | * | – |
| Track displacement | – | – | – | * |
| Layer thickness | – | – | * | – |
| Lamp current intensity | – | – | * | – |
| Tool scan speed | – | – | – | * |
| Gas Pressure | – | – | * | – |
| Interval time | – | – | * | – |
| Power | * | * | * | * |
| Slurry type | – | * | – | – |
| Slurry grit size | – | * | – | – |
| Slurry concentration | – | * | – | – |
| Tool type | * | * | – | * |
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.