Articles citing this article

The Citing articles tool gives a list of articles citing the current article.
The citing articles come from EDP Sciences database, as well as other publishers participating in CrossRef Cited-by Linking Program. You can set up your personal account to receive an email alert each time this article is cited by a new article (see the menu on the right-hand side of the abstract page).

Cited article:

Analysis of multipoint cutting tool temperature using FEM and CFD

Meenaskshi Sundaram Nagaraj, Chakaravarthy Ezhilarasan, A. John Presin Kumar, Rishab Betala

Manufacturing Rev., 5 (2018) 16

Published online: 2018-11-26

DOI: https://doi.org/10.1051/mfreview/2018013

This article has been cited by the following article(s):

Three-dimensional numerical simulation and optimization of heat transfer in high-speed drilling of XC48 steel

Nesrine Melzi, Adel Haddad, Mustapha Temmar, Abdessabour Benamor and Mohammed Ouali
The International Journal of Advanced Manufacturing Technology 140 (7-8) 4377 (2025)
https://doi.org/10.1007/s00170-025-16562-z

Amjed M. Kadhim, Abdulkareem F. Hassan and Qais Abdulhassan Rishack
2681 020016 (2022)
https://doi.org/10.1063/5.0124215

Experimental, Finite Element and Statistical Analysis of Temperature Generated in AISI 304 Stainless Steel during Drilling Operation

Amjed Majid, Abdulkareem Flaih Hassan and Qais Abdulhassan Abdulhassan Rishack
Kerbala Journal for Engineering Sciences 2 (2) 73 (2022)
https://doi.org/10.63463/kjes1010

Analysis of the cutting fluid behavior with a modified micro single-lip deep hole drilling tool

Ekrem Oezkaya, Andreas Baumann, Peter Eberhard and Dirk Biermann
CIRP Journal of Manufacturing Science and Technology 38 93 (2022)
https://doi.org/10.1016/j.cirpj.2022.04.003

Investigation and finite element simulation on the MRR and tool wear of aluminium silicon alloy during turning process

D Pritima, G Veerappan, L Mamundi Azaath and M Ravichandran
Surface Topography: Metrology and Properties 10 (2) 025027 (2022)
https://doi.org/10.1088/2051-672X/ac7066

An experimental investigation on the effect of radial rake angle and machining conditions during end milling on wear resistance and residual stress of nimonic 263 alloy

S Gowthaman and T Jagadeesha
Materials Research Express 6 (12) 126568 (2019)
https://doi.org/10.1088/2053-1591/ab5825